Figure 229. Assembling the PHM with processor in shipping tray
a. Align the triangular mark on the heat sink label with the triangular mark on the processor carrier
and processor.
b. Install the heat sink onto the processor-carrier.
c. Press the carrier into place until the clips at all four corners engage.
Step 5. (Optional) If the server has been pre-installed with a PHM filler and a socket filler, generally on
processor two, it is required to remove the fillers first before you proceed with further installation.
Figure 230. PHM filler removal
a. Open the retaining clip on each end of the memory module slots next to the left and right
sides of the processor two slot.
b.
Lift the PHM filler from the slots.
Step 6. Install the processor-heat-sink module to the processor board.
Chapter 5. Hardware replacement procedures 229
To Next Page
Loading...
