a. Press the release latches.
b.
Disengage the inner rails from the outer rails.
Step 2. Install the inner rail to the server.
Note: Make sure that the stamp “Front” always faces toward the front when assembling the inner
rails to the server.
Figure 71. Installing the inner rails
a. Align the slots on the inner rail with the corresponding T-pins on the side of the server.
b.
Slide the inner rail forwards until the T-pins lock into place.
Step 3. Repeat the previous step to the other rail.
Step 4. Carefully lift up the server with three people.
CAUTION:
Make sure three people are lifting the sever by holding the
1 lift points.
Chapter 5. Hardware replacement procedures 87
To Next Page
Loading...
