Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 421
8400 StateLine C | Reference manual
Diagnostics & error management
Error messages of the operating system
PS09: Par. format invalid [xx.0144.00009]
PS10: Memory module binding invalid [xx.0144.00010]
dF14: SW-HW invalid [xx.0145.00014]
dF18: BU RCOM error [xx.0145.00024]
dF25: CU RCOM error [xx.0145.00025]
dF26: Appl. watchdog [xx.0145.00026]
Response (Lenze setting printed in bold)
0: No Reaction : 1: Fault 2: Trouble 3: TroubleQuickStop 4: WarningLocked 5: Warning 6: Information
Cause Remedy
The code format is invalid.
• The error occurs while loading the parameter set.
Consultation with Lenze required.
Response (Lenze setting printed in bold)
0: No Reaction : 1: Fault 2: Trouble 3: TroubleQuickStop 4: WarningLocked 5: Warning 6: Information
Cause Remedy
Active device personalisation: The memory module and
the controller do not have identical binding IDs.
• Use memory modules/controllers with matching
binding IDs.
•Consult the machine manufacturer.
Note:
Lenze cannot modify e.g. a replacement device via
special access to make it work with a personalised
memory module.
Response (Lenze setting printed in bold)
0: No Reaction : 1: Fault 2: Trouble 3: TroubleQuickStop 4: WarningLocked 5: Warning 6: Information
Cause Remedy
Device error Consultation with Lenze required.
Response (Lenze setting printed in bold)
0: No Reaction : 1: Fault 2: Trouble 3: TroubleQuickStop 4: WarningLocked 5: Warning 6: Information
Cause Remedy
Device error Consultation with Lenze required.
Response (Lenze setting printed in bold)
0: No Reaction : 1: Fault 2: Trouble 3: TroubleQuickStop 4: WarningLocked 5: Warning 6: Information
Cause Remedy
Mains switching too frequent.
• Cyclic mains switching every 3 minutes is permissible.
• After switching the mains 3 times in one minute,
there must be a switching pause of 9 minutes.
• If the problem occurs again, you needs to consult
Lenze.
Response (Lenze setting printed in bold) Setting: C00580/1 (; Adjustable response)
: 0: No Reaction ; 1: Fault 2: Trouble 3: TroubleQuickStop 4: WarningLocked ; 5: Warning 6: Information
Cause Remedy
Time-out of the application. The required computing
time of the application exceeds the available computing
time.
Reduction of the function block interconnection or the
complexity of the application.
To Next Page
Loading...
