Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 12
1 About this documentation
1.3 Terminology used
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.3 Terminology used
Term Meaning
Controllers The Controller is the central component of the Lenze automation system which control
the motion sequences by means of the application software.
The Controller communicates with the field devices (inverters) via the fieldbus.
Engineering PC The Engineering PC and the Engineering tools installed serve to configure and
parameterise the system "Controller-based Automation".
The Engineering PC communicates with the controller via Ethernet.
Engineering tools Software solutions for easy engineering in all phases which serve to commission,
configure, parameterise and diagnose the Lenze automation system.
»EASY Navigator« – ensures easy operator guidance
• All convenient Lenze Engineering tools at a glance
• Tools can be quickly selected
• The clear structure simplifies the engineering process from the start
»EASY Starter« – easy-to-use tool for service technicians
• Especially designed for commissioning and maintaining Lenze devices
• Graphic surface with very few icons
• Easy to run online diagnostics, set parameters and perform
commissioning
• No risk of accidentally changing an application
• Loading of ready-to-use applications to the device
»Engineer« – multi-device engineering
• For all products in the Lenze portfolio
• Practical user interface
• Graphic interfaces make it easy to navigate
• Can be applied in every phase of a project (project planning,
commissioning, production)
• Parameter setting and configuration
»PLC Designer« –For programming processes
• Creating your own programs
• Programming Logic & Motion according to IEC 61131-3 (AWL, KOP, FUP,
ST, AS and CFC-Editor), based on CoDeSys V3
• Certified function blocks according to PLCopen part 1 + 2
• Graphic DIN 66025 Editor (G code) with DXF import
• Integrated visualisation for easy process visualisation
• All important information at a glance during the commissioning process
Fieldbus node Devices integrated in the bus system as, for instance, Controller and inverter
Field device
Inverters Generic term for Lenze frequency inverters, servo inverters
PLC Programmable Logic Controller
(PLC)
Bus systems
CAN CAN (Controller Area Network) is an asynchronous, serial fieldbus system.
CANopen® is a communication protocol based on CAN. The Lenze system bus (CAN on
board) operates with a subset of this communication protocol.
CANopen® is a registered community trademark of the CAN user organisation CiA® (CAN
in Automation e. V.).
DeviceNet™ is a fieldbus system based on CAN (Controller Area Network).
DeviceNet™ is a trademark and patented technology, licensed by the user organisation
ODVA (Open DeviceNet Vendor Association), USA.
EtherCAT® (Ethernet for Controller and Automation Technology) is an Ethernet-based
fieldbus system which fulfils the application profile for industrial real-time systems.
EtherCAT® is a registered trademark and patented technology, licenced by Beckhoff
Automation GmbH, Germany.
To Next Page
Loading...