Lenze I/O system 1000 - Parameterising I;O modules in the PLC Designer

4 Configuring the I/O system in the »PLC Designer«
4.4 Parameterising I/O modules in the »PLC Designer«
73
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.4 Parameterising I/O modules in the »PLC Designer«
This chapter uses examples to describe how to parameterise I/O compound modules in the »PLC
Designer«.
4.4.1 Parameterising the I/O modules at the backplane bus of the Controller
If you double-click an I/O compound module in the device view of the »PLC Designer«, the settings
and properties of the I/O compound module are displayed in the editor view.
•Use the Parameter tab to set the parameters required for the selected I/O compound module
(for this example, an "EPM-S400" has been selected):