Lenze I/O system 1000 - Parameterising I;O Modules on the Ethercat Bus Coupler Module

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 74
4 Configuring the I/O system in the »PLC Designer«
4.4 Parameterising I/O modules in the »PLC Designer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.4.2 Parameterising I/O modules on the EtherCAT bus coupler module
If you double-click the EtherCAT bus coupler module (EPM-S130) in the device view of the »PLC
Designer«, the settings and properties of the bus coupler modules are displayed in the editor view.
•The All parameters tab displays the parameters of the bus coupler module and all attached I/O
compound modules in a hierarchical structure.
• The following example shows the setting parameters of an "EPM-S400":
As an alternative, you can have the settings and features of a single I/O compound module
displayed by double-clicking the corresponding I/O compound module in the device view.
•Use the Modules tab to set the parameters required for the selected I/O compound module (for
this example, an "EPM-S400" has been selected):