Lenze I/O system 1000 - Connecting the I;O system to the Lenze Controller

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 48
4 Configuring the I/O system in the »PLC Designer«
4.1 Connecting the I/O system to the Lenze Controller
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1 Connecting the I/O system to the Lenze Controller
• Plug the Controller and modules of the I/O system 1000 onto the fixing rail.
• Always arrange the modules from left to right starting with the Controller directly followed by
a power supply module EPM-S701 to the right or an I/O bus coupler module.
• The modules must always be installed directly next to each other.
• Free slots between the modules are not permissible because otherwise the backplane bus
would be interrupted.
• The side contacts of the last module always must be covered with the supplied contact cover.
Otherwise, the modules may be damaged by short circuit or static discharge.
[4-1] Example: Interfaces on the Controller 3231 C
 Mounting instructions of the I/O system and the Controller
Here you will find detailed information on how to install the devices.
Observe the safety instructions.
 Controller reference manual - Parameterising and programming
Detailed information on the Lenze Controllers is provided here.
32xxC_009
A Ethernet interface "LAN 1a"
B Ethernet interface "LAN 1b"
C EtherCAT interface
G Slot for optional communication card (MC-Card)
H Contacts for backplane bus