Lenze I/O system 1000 - Configuring the I;O system in the PLC Designer

4 Configuring the I/O system in the »PLC Designer«
47 Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4 Configuring the I/O system in the »PLC Designer«
This chapter describes how to set up communication with the »PLC Designer« between the
Engineering PC and the I/O system 1000.
If the I/O system 1000 is used in line with the Lenze "Controller-based Automation" system, only the
...
EtherCAT communication
( 323) ,
CANopen communication
( 78) ,
PROFIBUS communication
( 215) ,
PROFINET communication
( 464) ,
are supported.
 More information on the bus systems and configuration can be found in these
communication manuals:
• Controller-based Automation EtherCAT®
• Controller-based Automation CANopen®
• Controller-based Automation PROFIBUS®
• Controller-based Automation PROFINET®