Lenze I/O system 1000 - Configuring the I;O Modules at the Backplane Bus of the Lenze Controller

4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
53
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.3.2 Configuring the I/O modules at the backplane bus of the Lenze Controller
The Lenze Controller consists of the following components:
• I/O bus coupler module: controller with a PLC control in the form of a soft PLC.
• I/O compound modules: Up to 64 modules which are connected to the controller via the Lenze
backplane bus.
[4-2] Schematic hardware structure of the Lenze Controller with added I/O compound modules
In order to access the modules by a PLC program (read input signals and write output signals), the
real station layout, i.e. the physical arrangement of the I/O compound modules has to be mapped
in the Device view of the »PLC Designer«:
[4-3] Example: Mapping of the physical topology (module 1 to module 7) in the device view in the »PLC Designer«