Lenze I/O system 1000 - Setting the communication path and going online

3 Configuring the I/O system in the »Engineer«
3.3 Setting the communication path and going online
43
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.3 Setting the communication path and going online
 How to configure an online connection via system bus (CANopen):
1. Go to the Project view and select the I/O system 1000 to be connected online:
2. Select the menu command OnlineSet communication path and go online.
If the changes you have made on the project have not been accepted yet, first a query on
whether an update is to be carried out is effected.
If an update is to be carried out:
•Click Yes to open the Build project dialog box.
•Click Build in the Build project dialog box to update the changed project elements.
• When the update is completed, a note appears whether the update was successful.
3. In the Communication path dialog box, select the "CAN" entry from the Bus connection list
field:
 Note!
The communication settings need to be made only once when the connection to the
device is established for the first time. If the Go online command is executed again, the
Communication path dialog box will not be displayed again and an online connection
will be established immediately via the bus connection set for the device.
To change a communication path that has already been set, go to the Online menu and
execute the Set communication path and go online command.