1 About this documentation
9 Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
This documentation shows the implementation of the modular I/O system 1000 into the Lenze
"Controller-based Automation" system.
It provides an overview of the device architecture, the available bus coupler modules and the I/O
compound modules. Moreover, information is provided on how to use different fieldbuses as well
as information on how to configure and parameterise the I/O system with the engineering tools
»PLC Designer« and »Engineer«.
Target group
This documentation is directed at all persons who would like to parameterise, configure, and
diagnose the Lenze I/O system 1000 using the »PLC Designer« and »Engineer« engineering tools.
Information regarding the validity
The information in this documentation applies to:
Screenshots/application examples
All screenshots in this documentation are application examples. Depending on the firmware
version of the device and software version of the installed engineering tools, the screenshots in this
documentation may differ from the screen representation.
Read the I/O system 1000 system manual before you start working.
The system manual contains safety instructions which must be observed!
Product series Type designation Version
I/O systems I/O system 1000 From hardware version 1B, software version 10
To Next Page
Loading...