Lenze I/O system 1000 - Parameterising the Time Stamp; Digital Inputs with Time Stamp Function - EPM-S207; Digital Outputs with Time Stamp Function - EPM-S310

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 366
7 EtherCAT communication
7.9 Parameterising the time stamp
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.9 Parameterising the time stamp
7.9.1 2 digital inputs with time stamp function - EPM-S207
Parameter data
7.9.2 2 digital outputs with time stamp function - EPM-S310
Parameter data
Subindex Name Description/value Lenze
01 Length - process
image input data
Length of input data (backplane bus communication); the values
are specified by the system. Other values are not permissible.
0x14 or
0x3C(fix)
02 Length - process
image output data
Length of output data (backplane bus communication); the
values are specified by the system. Other values are not
permissible.
0x00 (fix)
03 Input delay DI 0 0x00 = 1 s
0x02 = 3 s
0x04 = 10 s
0x07 = 86 s
0x09 = 342 s
0x0C = 273 s
No other values are permissible.
0x02
04 Input delay DI 1 0x02
05 Edge 0-1 at DI x Time stamp entry on rising edge
Bit 0: DI 0 (0: inhibit, 1 = enable)
Bit 1: DI 1 (0: inhibit, 1 = enable)
Bits 7 ... 2: reserved
0x00
06 Edge 1-0 on DI x Time stamp entry on falling edge
Bit 0: DI 0 (0: inhibit, 1 = enable)
Bit 1: DI 1 (0: inhibit, 1 = enable)
Bits 7 ... 2: reserved
0x00
Subindex Name Description/value Lenze
01 Length - process
image input data
Length of input data (backplane bus communication); the values
are specified by the system. Other values are not permissible.
0x14 or
0x3C(fix)
02 Length - process
image output data
Length of output data (backplane bus communication); the
values are specified by the system. Other values are not
permissible.
0x00 (fix)