Lenze I/O system 1000 - Parameterising I;O modules in the Engineer

3 Configuring the I/O system in the »Engineer«
3.4 Parameterising I/O modules in the »Engineer«
45
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.4 Parameterising I/O modules in the »Engineer«
This chapter uses examples to describe how to parameterise I/O compound modules in the
»Engineer«.
If you select the I/O system 1000 in the project view of the »Engineer«, the Workspace displays the
settings and features of the I/O system.
•The All parameters tab displays the parameters of the bus coupler module and all attached I/O
compound modules in a hierarchical structure.
• The following example shows the setting parameters of an "EPM-S400":
As an alternative, you can have the settings and features of a single I/O compound module
displayed by selecting the corresponding I/O compound module in the Project view.
•Use the Parameter tab to set the parameters required for the selected I/O compound module
(for this example, an "EPM-S400" has been selected):
 Detailed information on the function of the single I/O modules can be found in the
system manual for the I/O system 1000.