2 Product description
2.6 Counter modules EPM-S600 ... EPM-S603 – control and status words
27
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.6 Counter modules EPM-S600 ... EPM-S603 – control and status words
2.6.1 Status word EPM-S600
* The bits are set until reset with RES_SET (bit 6 control word)
Bit Name Function
0 STS_SYNC Reset was active
1 STS_CTRL_DO Is set if the digital output is enabled
2 STS_SW-GATE Software gate status (set if SW gate active)
3 STS_RST Status of the reset input
4 STS_STRT Hardware gate status (set if HW gate active)
5 STS_GATE Status of internal gate (set if internal gate active)
6 STS_DO Status of digital counter output (DO)
7 STS_C_DN Status set in the case of backward counter direction
8 STS_C_UP Status set in the case of forward counter direction
9 STS_CMP* Status of comparator is set if the comparison condition is met.
If the comparison is deactivated, (counter mode byte 1 = 0b000), the bit has
no function.
10 STS_END* Status set if final value has been reached
11 STS_OFLW* Status set in the case of an overflow
12 STS_UFLW* Status set in the case of an underflow
13 STS_ZP* Status set in the case of a zero crossing
14 STS_LTCH Status of the latch input
15 - Reserved
To Next Page
Loading...