Lenze I/O system 1000 - 8.2 Access to the I;O system 1000

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 406
8 DeviceNet communication
8.2 Access to the I/O system 1000
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2 Access to the I/O system 1000
The following illustration shows the access under DeviceNet to the areas "I/O", "parameters" and
"diagnostics".
 Note!
Please note that the supply and terminal modules do not have any type identification
and thus cannot be recognised by the DeviceNet bus coupler.
In the following, slots within the DeviceNet are called DeviceNet slots. Counting always
starts at 1.
EPM-S150
EPM-S200
DI 2x
DC24V
Slot 1
EPM-S301
DO 4x
DC24V
Slot 2
EPM-S400
AI 2x
12Bit
Slot 3
EPM-S701
Slot 4
EPM-S600
1x 32Bit
Slot 5
EPM-S201
DI 4x
DC24V
Slot 6
I data
O data
I data
Bytes:
1
O data
I data I data
Bytes:
4
Bytes:
12
Bytes:
1
Bytes:
1
Bytes:
10
Slot: Output: Slot: Input:
1 2
3 45
4
DeviceNet Device (Slave)
Param:
1 2
3 45
4
ParamParam
Diag Diag Diag Diag Diag
Diag:
DeviceNet-Slot: Slot 1 Slot 2 Slot 3 - Slot 4 Slot 5
I/O Mapping Parameterization
DeviceNet Scanner (Master)Configuration tool
Diagnostic