Lenze I/O system 1000 - Page 52

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 52
4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4. Go to the Standard project dialog window and select the target system from the
Controller type selection list.
Further optional project settings
Selection of the Controller firmware version
Selection of the compiler version
Selection of the programming language:
• Sequential function chart (AS)
• Instruction list (AWL)
• Continuous Function Chart (CFC)
• Function block diagram (FUP)
• Ladder diagram (KOP)
• Structured text (ST)
5. Confirm the selection by clicking OK.
Next steps:
The following chapter use examples to describe how to add the available I/O system depending on
the fieldbus used to the Device view of the »PLC Designer«:
Configuring the I/O modules at the backplane bus of the Lenze Controller
Configuring I/O modules on the EtherCAT bus coupler module
Configuring I/O modules on the CANopen bus coupler module