Lenze I/O system 1000 - Page 54

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 54
4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
The following step-by-step instructions describe the manual
mapping of the available station
layout in the device view of the »PLC Designer«.
 Tip!
When an online connection has been established to the Lenze Controller, you can also start
an automatic search for I/O compound modules available on the backplane bus of the
Controller by executing the Start Search command in the context menu of the
"I_O_Modul_Koppler.
 How to map the station layout of the »PLC Designer«:
1. Execute the Add device... command in the context menu of the "I_O_Modul_Koppler:
2. Select the physically first I/O compound module in the Add device dialog box (for this
example, an "EPM-S200" has been selected):
3. Click Add device to add the selected device to the "I_O_Modul_Koppler".
•The Add Device dialog box remains open.