Lenze I/O system 1000 - Page 55

4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
55
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4. Proceed as described before to add all other available I/O compound modules of the Device
view.
• Sample representation:
5. Click the Close button to close the Add Device dialog box again.
 Tip!
• If configured correctly and after "going online" and starting the PLC, all modules in the
device view are marked with the symbol.
• In the event of an error, i.e. if the configuration deviates from the physical arrangement,
the modules are marked with the symbol.