Lenze I/O system 1000 - Page 49

4 Configuring the I/O system in the »PLC Designer«
4.1 Connecting the I/O system to the Lenze Controller
49
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Connection of the Engineering PC
Connect the Ethernet interface "LAN 1a" to the Engineering PC using a standard Ethernet network
cable
Connection via EtherCAT
Connect the RJ45 port on the EtherCAT bus coupler module (EPM-S130) to the EtherCAT interface of
the Controller using a standard Ethernet network cable.
Connection to an optional communication card (MC-Card)
For all other fieldbus systems, optional communication cards are available for the Controllers.
The interfaces of the communication card have to be connected to a corresponding bus coupler
module.