Lenze I/O system 1000 - Page 132

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 132
5 CANopen communication
5.9 Parameterising temperature measurement
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
I-3107/x Conversion time
channel 1
You can set the transformer speed as a function of the
interference frequency suppression (see 0x3105/x) for each
channel.
0 (0x00): At 50 Hz: 324.1 ms/channel 16 bits; at 60 Hz: 270.5
ms/channel 16 bits
1 (0x01): at 50 Hz: 164.2 ms/channel 16 bits; at 60 Hz: 137.2
ms/channel 16 bits
2 (0x02): At 50 Hz: 84.2 ms/channel 16 bits; at 60 Hz: 70.5
ms/channel 16 bits
3 (0x03): At Hz: 44.1 ms/channel 16 bits at 60 Hz: 37.2 ms/
channel 16 bits
4 (0x04): At 50 Hz: 24.2 ms/channel 16 bits; at 60 Hz: 20.5
ms/channel 16 bits
5 (0x05): At 50 Hz: 14.2 ms/channel 16 bits; at 60 Hz: 12.2
ms/channel 16 bits
6 (0x06): At 50 Hz: 9.2 ms/channel 16 bits; at 60 Hz: 8.0 ms/
channel 16 bits
7 (0x07): At 50 Hz: 6.6 ms/channel 15 bits; at 60 Hz: 5.9 ms/
channel 15 bits
8 (0x08): At 50 Hz: 4.2 ms/channel 13 bits; at 60 Hz: 3.8 ms/
channel 13 bits
0x02
I-3108/x Upper limit value
(HIGH byte) channel
1
You can define an upper or lower limit value for each
channel. For this you can only specify values from the
nominal range, otherwise you'll receive a parameterisation
error. By specification of 0x7FFF for the upper or 0x8000 for
the lower limit value, the corresponding limit value is
deactivated.
If your measured value is outside a limit value and you have
activated the limit value monitoring, a process alarm is
triggered.
0x7F
I-3109/x Upper limit value
channel 1 (LOW byte)
0xFF
I-310A/x Lower limit value
(HIGH byte) channel
1
0x80
I-310B/x Lower limit value
channel 1 (LOW byte)
0x00
Channel 2
I-310C/x Function channel 2 See channel 1 0xC1
I-310D/x Conversion time
channel 2
See channel 1 0x02
I-310E/x Upper limit value
channel 2 (HIGH
byte)
0x7F
I-310F/x Upper limit value
(LOW byte) channel 2
0xFF
I-3110/x Lower limit value
channel 2 (HIGH
byte)
0x80
I-3111/x Lower limit value
(LOW byte) channel 2
0x00
I-3112/x Reserved 0
... ... ...
I-311D/x Reserved 0
Index/subindex Name Description/value Lenze