Lenze I/O system 1000 - Page 364

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 364
7 EtherCAT communication
7.8 Parameterising the encoder evaluation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
06 Bit length of encoder
data
Enter the bit length of the encoder data here. Depending on the
encoder, the encoder data consist of the current encoder value
with subsequent bits. The total length has to be specified here.
More information on this can be found in the data sheet for your
encoder.
7 (0x07) = "8 bits"
8 (0x08) = "9 bits"
9 (0x09) = "10 bits"
10 (0x0A) = "11 bits"
11 (0x0B) = "12 bits"
12 (0x0C) = "13 bits"
13 (0x0D) = "14 bits"
14 0x0E) = "15 bits"
15 (0x0F) = "16 bits"
16 (0x10) = "17 bits"
17 (0x11) = "18 bits"
18 (0x12) = "19 bits"
19 (0x13) = "20 bits"
20 (0x14) = "21 bits"
21 (0x15) = "22 bits"
22 (0x16) = "23 bits"
23 (0x17) = "24 bits"
24 (0x18) = "25 bits"
25 (0x19) = "26 bits"
26 (0x1A) = "27 bits"
27 (0x1B) = "28 bits"
28 (0x1C) = "29 bits"
29 (0x1D) = "30 bits"
30 (0x1E) = "31 bits"
31 (0x1F) = "32 bits"
0x18
Subindex Name Description/value Lenze