Lenze I/O system 1000 - Page 77

4 Configuring the I/O system in the »PLC Designer«
4.5 Error messages (backplane bus)
77
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
137 Too many tasks for processing I/O modules Reduce the number of tasks.
Three tasks are the
maximum.
138 Device description does not contain a device type Contact Lenze
139 Error while writing the initialisation parameters Contact Lenze
140 No definition for number of channels in device description Contact Lenze
181 Synchronisation of the I/O system incorrect Contact Lenze
200 SDO timeout Contact Lenze
220 SDO communication error Contact Lenze
221 Physical I/O module topology could not be read. Contact Lenze
222 I/O system driver could not be opened. Contact Lenze
Error number Error text Remedy