Software overview Chapter 3
Mastersizer 3000 Page 3-17
Company Information
The Company name and Logo can be added. This information will then be dis-
played on all reports.
Select to assign a logo, or to restore the default logo image.
Extended software features
The same software is used to control both variants of the Mastersizer instruments -
the Mastersizer 3000 and the Mastersizer 3000E, though some software features are
removed for a 3000E installation.
The Mastersizer 3000E software focuses on just the necessary software features for
operating the instrument - this is termed the Basic feature set.
Installing the Extended feature set will enable the Mastersizer 3000E to utilise
the full range of the standard software and its additional features.
With the Mastersizer 3000 the extended software features are installed by default
and will always be available for selection.
.The icon will be greyed out if not installed.
For the Mastersizer 3000E to have access to these features a feature key needs to
be installed. Contact your local Malvern representative to upgrade the Mastersizer
3000E basic software to the extended software version?
With the feature key installed, three levels of configuration are available:
Basic feature set - disable all extended features (shown in table below) and
run as a Mastersizer 3000E.
Extended feature set - enables all extended features and run as a Mastersizer
3000.
Custom feature selection - all extended features can be selected individually.
Tick/untick the features as required and press ok to save.
To Next Page
Loading...
Need help?
General
