Chapter 4 Making measurements
Page 4-6 MAN 0474
Running an SOP (Hydro units)
If you are using a wet dispersion unit (the Hydro LV/MV/EV) work through the
steps in the order given here. No manual control of the dispersion units is required
after loading the sample; the software controls all settings.
1. Select Run SOP from the Measurements section of the ribbon.
2. The SOP Selector window is shown, which initially presents all SOPs filtered
for the connected accessory (
Accessory filtered). Alternatively, deselect
the Accessory filtered button to show those that are not specific to the
connected accessory.
To Next Page
Loading...
