Starting/turning off the engine for driving
4.1 Starting the engine from the driver's cab
4 - 14 3 112 993 en Operating manual GMK 6400
12.07.2013
Conducting the lamp test
• If necessary, open the main menu ö and press button (1) once.
The
Settings submenu opens.
• Press the button (1).
The lamps on the ECOS control unit remain lit until you let go of the but-
ton again.
If necessary, you can set the minimum brightness of the display;
à p. 4 - 15.
Equalisation of the
switching states
When the ignition is switched on, the switching states of the differential
locks and the separate steering are compared.
The state last saved is retrieved.
In the main menu, the corresponding symbols
(1) are shown and the electronics system trig-
gers the switching operations.
The displays (2) and (3) show the current
switching states.
If the display (2) does not show the symbol
that corresponds to the switching process,
you must actuate the steering so that the lock-
ing processes are performed mechanically;
à Switching to normal steering mode, p. 5 - 69.