Starting/turning off the engine – for crane operation
10.1 When starting the engine for the first time of the day
10 - 10 3 112 993 en Operating manual GMK 6400
12.07.2013
10.1.7 Checks after starting the engine
• Check the lamp (1) on the ECOS control unit immediately after starting the
engine.
The lamp (1) must go out approx. 10 seconds after starting the engine.
• Press the button (1) once. This opens the Warning submenu.
• If the symbol (2) is red, switch off the engine immediately.
• Check the oil level; à Maintenance manual.
• Add oil if necessary. If the error message persists, refer to Manitowoc
Crane Care
.
If other symbols in this menu are displayed in red; à Warning submenu,
p. 11 - 111.
• Also check the following lamps on the side panel.
– If the lamp (2) does not go out or lights up while the engine is running,
switch the engine off and look for the cause.
– If the lamp (1) does not go out or lights up while the engine is running,
there is a malfunction in the flame start system.
à Malfunctions in the engine, p. 7 - 27
More information can be found in the
Monitoring submenu; à p. 10 - 11.
S
Risk of damage to the engine
If the lamp (1) does not go out after about 10 seconds, perform the follow-
ing check and, if necessary, turn off the engine immediately.
The engine can be damaged by running it when the oil pressure is too low.
To Next Page
Loading...
