Starting/turning off the engine – for crane operation
10.1 When starting the engine for the first time of the day
Operating manual GMK 6400 3 112 993 en 10 - 7
12.07.2013
10.1.5 Adjusting display brightness
The brightness of the displays is automatically regulated by the ECOS and
the
RCL displays and depends on the brightness of the operating environ-
ment. You can manually set a default minimum brightness for the
ECOS and
RCL displays.
• If necessary, open the main menu ö and press the button (1) once.
This opens the
Settings submenu.
• Press the (3) button once.
A red bar (2) appears below the display (1).
• Set the desired minimum brightness with
the switch (4).
The brightness of the display changes while
setting and you can view the set value (0 to
100%) on the display (1).
The brightness set here is the minimum value
for automatic regulation.
H
There is no automatic regulation if you set the brightness to 100%.
The displays then always show maximum brightness.
You can cancel the entry at any time using the button (1). The settings are
then reset.
• Apply the entered minimum brightness – press the button (2) once.
The red bar below the display disappears. The brightness is automatically
regulated between the newly set value and 100%.
To Next Page
Loading...
