Crane operation
11.6 Work break
Operating manual GMK 6400 3 112 993 en 11 - 129
12.07.2013
11.6.2 In case of work breaks of more than 8 hours
•
Retract all telescopic sections
• Set down the main boom on the boom rest
• Switch off the slewing gear
– The lamp in the (1) button must be dimly lit
– Lamp (2) must light up – slewing gear brake engaged
• Switch the engine off, turn the ignition key to position 0 and remove it
• Switch off all electrical loads
• Switch off the battery master switch. This will not interrupt the run-down
period of the heater.
To secure the
truck crane
• Secure the truck crane against unauthorised use by:
– Stowing away the hand-held control in the crane cab
– Removing the ignition key
– Locking the crane cab
G
Danger due to unauthorised use.
Always lock the hand-held controller before you leave the truck crane. In
this way you can prevent unauthorised persons from starting the engine
with the hand-held control.
To Next Page
Loading...
