Starting/turning off the engine for driving
4.1 Starting the engine from the driver's cab
Operating manual GMK 6400 3 112 993 en 4 - 15
12.07.2013
4.1.8 Display – setting the brightness
The brightness of the displays is regulated automatically by the ECOS,
depending on the ambient brightness. You can set a minimum degree of
brightness manually, which is always observed when the brightness is reg-
ulated.
• If necessary, open the main menu ö and press the button (1) once.
The
Settings submenu opens.
• Press the button (3) once.
A red bar (2) appears below the display (1).
• Set the required minimum brightness with
the switch (4).
The brightness of the display changes during
the setting procedure and you can view the set
value (0 to 100%) on the display (1).
The degree of brightness which you set here is
the minimum value for automatic regulation.
H
There is no automatic regulation if you set 100%.
The displays always have maximum brightness.
You can cancel the entry at any time using button (1). The settings are then
reset.
• Adopt the minimum brightness entered – press the button (2) 1 x.
The red bar below the display disappears. The brightness is automatically
regulated between the newly set value and 100%.
To Next Page
Loading...
