Rigging work
12.5 Starting the engine for driving for rigging work
Operating manual GMK 6400 3 112 993 en 12 - 27
12.07.2013
12.5.3 Starting/turning off the engine from the outrigger control units
Requirements The following requirements must be met before you can start the engine for
driving from the outrigger control units:
– The ignition in the driver's cab is switched on
– The ignition is switched off in the crane cab
– The lamp in the button (1) lights up
Starting the
engine
All activities and inspections required to start the engine must be carried out
before starting the engine;
à p. 4 - 1.
• Press the (3) button once – the engine starts
Turning off the
engine
• Press the (1) button once – the engine goes off
To Next Page
Loading...
