Driving
5.1 Before driving
5 - 16 3 112 993 en Operating manual GMK 6400
12.07.2013
5.1.5 Setting the tachograph
The diagram sheets (24-hour discs) can be inserted in the tachograph for
two drivers simultaneously.
As a crane operator, you are obligated to set each activity on the tacho-
graph.
H
This section only describes the basic operation of the tachograph (inserting
diagram sheets, setting time groups, operating errors).
Before operation, also observe the information in the tachograph manufac-
turer's separate operating instructions.
There you will find detailed information (marking the diagram sheets, mal-
functions, etc.).
Requirements To set the tachograph, the following requirements must be met:
– The ignition is switched on
– The truck crane is stationary
– No error message is displayed
If malfunction
occurs
Check that a malfunction has occurred.
If there is a malfunction in the tachograph (1),
the lamp (2) on the tachometer lights up.
If a malfunction has occurred, the
Tachograph
display (1) will show an error message;
à Separate operating manual by the tacho-
graph manufacturer.
S
Risk of damage to the tachograph drawer
Open the tachograph drawer only to insert or remove diagram sheets and
do not use the opened drawer as a shelf or surface (e.g. to mark the dia-
gram sheets). This prevents contamination and damage.
To Next Page
Loading...
