Starting/turning off the engine for driving
4.1 Starting the engine from the driver's cab
4 - 16 3 112 993 en Operating manual GMK 6400
12.07.2013
4.1.9 Start the engine
H
This section describes only how to start the engine from the driver's cab.
You can also start the engine with the hand-held control;
à p. 12 - 23,
or from the operating elements of the outriggers;
à p. 12 - 23.
Refer to the separate operating instructions provided by the engine manu-
facturer for the operation of the engine. The engine can only be started if
– The bridging plugs have been inserted in all sockets of the carrier and
superstructure for the hand-held control;
à p. 3 - 28.
– The lamp (1) has gone out (superstructure ignition off).
• Check that the vehicle parking brake is locked.
If the brake is engaged, the parking brake lever will point downwards.
• Switch the transmission to neutral position N; à p. 5 - 24.
Only in this shift position can the engine be started.
H
If the engine is equipped with a flame start system; à With flame start sys-
tem
, p. 4 - 18.
To Next Page
Loading...
