Additional page GMK6400 3 113 060 en 5
22.01.2014
Inspecting/replacing safety harness
H
Make sure your personal protective equipment is also regularly inspected.
In order to do this, observe the information provided by the manufacturer.
Inspection The safety harness on the main boom must be inspected for damage at reg-
ular intervals.
• Check all fastening and connecting parts for
damage, wear, mobility and deformations.
Replacement Make sure damaged, worn, or deformed fastening or connecting parts are
immediately replaced by
Manitowoc Crane Care or an authorised GROVE
dealer or your repair crew.
H
The safety harness must always be replaced completely following stress
caused by a fall, even if no damage can be detected.
G
Risk of accidents if inspections are not carried out
Make sure the safety harness is inspected regularly.
This will prevent component failure in cases of danger.
A safety harness only ensures protection from falling if it is regularly
inspected.
To Next Page
Loading...
Need help?
General
