Rigging work
12.5 Starting the engine for driving for rigging work
12 - 24 3 112 993 en Operating manual GMK 6400
12.07.2013
Starting the
engine
All activities and inspections required to start the engine must be carried out
before starting the engine;
à p. 4 - 1.
• Wait until the lamps (1) and (2) light up
If the lamp
(2) does not go on or flash after about 20 seconds, there is a mal-
function;
à p. 14 - 20.
• Press the (3) button once – the engine starts
The following buttons are now active on the hand-held control:
– All buttons on the control panel (1)
– The function buttons (3)
– All buttons on the control panel (4)
– The button (6) for the horn on the carrier
The
button (2) and button (5) are inactive.
The
Outrigger control units are locked after connection of the hand-held con-
trol.
H
You can start the engine from the crane cab, but the operating elements for
crane operation are disabled after starting the vehicle engine with the hand-
held control.
Turning off the
engine
You cannot turn off the engine with the ignition lock in the driver's cab, if it
was started with the hand-held control.
• Press the (1) button once – the engine goes off
To Next Page
Loading...
Need help?
General
