MIMAKI CFL-605RT - Back Side Cut Offset Measurement and Adjustment

4-21
Confirm the following when failed in cutting correctly
1
1
1
4
Register Mark Reading Functions
10
Measure the distance from the set guide plate to
the pattern
11
Press the jog key to select A or B.
12
Press the key.
13
Press to enter the value measured in step
10.
X(length) : 0 ~ 50.0mm
Y : 0 ~ 50.0mm
14
Press key, and determine the adjustment
value.
• When cancel the registration, press key.
• Repeat Step 11 and later, and enter the value of X and Y.
• When quit, press key in the display of step 11.
• Please strike exactly against the set guide plate.
• Please press the media against without gap to the set guide plate.
When it is pressed against the set guide plate, please make sure the set guide plate is not floated.
Pattern
Y
X
Set guide plate
<BACKS I DECUT OFS>


CUT OFFSE X : 2 0 . 0mm
<BACKS I DECUT OFS>
CUT OFFSE X : 1 5 . 0mm
<BACKS I DECUT OFS>


CUT OFFSE X : 1 5 . 0mm