This Section....
... describes the setup operations required to connect the unit to a PC after unpacking it.
Installation .............................................. 1-2
Names and Functions of Parts ............... 1-4
Main Unit ..................................................1-4
Head .........................................................1-5
Operation Panel .......................................1-6
Cable Connections ................................. 1-7
Connecting the Power Cable .................... 1-7
Connecting the Interface Cable ................ 1-7
Emergency Stop..................................... 1-8
Applying an Emergency Stop ...................1-8
Resetting an Emergency Stop ..................1-8
Preparing the Cutting Panel ................... 1-9
Attach the felt mat ....................................1-9
Inserting the Set Guide Plates ..................1-9
Blades and Workpieces........................ 1-10
Workpiece Types that Can be Cut (Guide) 1-
10
Blade Types that Can Be Used .............. 1-10
Mounting Tools ..................................... 1-11
Mounting the Pen or Swivel Blade ..........1-11
Mounting the Tangential Cutter ..............1-14
Mounting the Grid Roller .........................1-16
Mounting the Reciprocating Cutter .........1-17
Attach the Work Holder ........................ 1-19
Local Status / Remote Status ............... 1-20
Local Status and Displays ......................1-20
Remote Status and Displays ..................1-20
Matching the PC Specifications............ 1-22
Setting the Command Origin ..................1-22
Matching the Plotter Specifications ...... 1-23
Setting Automatic Head Retraction ...... 1-24
Setting the Vacuum .............................. 1-25
Enabling / Disabling the Vacuum Automatic
OFF Function ..........................................1-25
Interlock between Remote Key and
Vacuum Key ...........................................1-26
Chapter 1
Setup
To Next Page
Loading...
