6-12
Circle Correction
The unit can conduct correction for five circles of different radius.
1
Press the key in the local mode.
2
Press the jog key or to select [TOOL
ADJUST] .
3
Press the key.
4
Press the jog key to select tool.
• Set value: REC.CUTTER1~2, CUTTER, ROLLER1~3
5
Press the key.
6
Attach the selected tool ( P.2-22).
7
Press the jog key to select [CIRCLE
ADJUST].
8
Press the key.
Circle type for correction Set values
Radius (R) ≤ 5 mm - 20° ~ + 20°
5 mm < Radius (R) ≤ 10mm - 20° ~ + 20°
10 mm < Radius (R) ≤ 20mm -9.8° ~ + 9.8°
20 mm < Radius (R) ≤ 50mm -9.8° ~ + 9.8°
50 mm < Radius (R) ≤ 100mm -9.8° ~ + 9.8°
100 mm < Radius (R) -9.8° ~ + 9.8°
• In some cases, this cannot be corrected by the CAD system.
• First, set arc correction to Enable.
If arc correction is not set to Enable, this offset will not be applied to the drawing (cut).
Locus
Direction of cutting
<FUNCT ION>
SET UP [ ENT ]
<FUNCT ION>
TOOL ADJUST [ ENT ]
<TOOL SELTECT>
TOOL : B : REC . CUTTER1
<TOOL SELTECT>
TOOL : B : REC . CUTTER1
<REC . CUTTER1 ADJ >
CIRCLE ADJUST [ ENT ]
<C I RCLE ADJUST>
R<5 : 0 . 0 º
To Next Page
Loading...
