v
Troubleshooting .................................................... 6-14
Unit does not operate when the power is turned ON ..6-
14
Unit does not operate after the CAD data is sent ....6-14
An error occurs when the data is sent .....................6-14
Tool lifts up the paper ..............................................6-15
Drawn lines are broken or smudged .......................6-15
No reciprocating movement ....................................6-15
Problems Causing an Error Display ..................... 6-16
Non-fatal Errors .......................................................6-16
Status message ......................................................6-19
Sample Cut ........................................................... 6-20
Perform SAMPLE CUT to Find out the Cause of
Cutting Error. ...........................................................6-21
CFL-605RT Specifications .................................... 6-23
To Next Page
Loading...
