iv
Permitted Arrangements of Register Marks and the
Design ...................................................................... 4-3
Prohibited Drawing Areas around Register Marks ... 4-3
Guide to Register Mark Separation and Register Mark
Size ........................................................................... 4-5
Register Mark Colors ................................................ 4-6
Bleeding or Smudging of Register Marks ................. 4-6
Setting Register Mark Detection ............................ 4-7
Precautions Related to Register Mark Detection ...... 4-7
Setting Register Mark Detection ............................... 4-9
Detecting Register Marks ..................................... 4-10
Using the Light Pointer to Check the Workpiece Tilt 4-10
Setting height of register mark ................................4-11
Register Mark Detection Procedure ....................... 4-12
Continuous Cutting of Register Marks ................ 4-13
Confirm the following when failed in cutting
correctly ............................................................... 4-14
Alignment of MARK SENSOR ................................ 4-14
Check the sensor for the registration mark
detection ................................................................. 4-16
Correct the light pointer position .............................4-19
Setting of the back side cut offset ........................... 4-20
Chapter 5 Daily Maintenance
Daily Maintenance ................................................. 5-2
Cutting Panel Surface ............................................... 5-2
Covers ...................................................................... 5-2
Care of the cutter blade ............................................ 5-2
Unit B ........................................................................ 5-3
Cleaning the Vacuum Filter ...................................... 5-4
Cleaning the Register Mark Sensor .......................... 5-5
Supplied items ....................................................... 5-6
Chapter 6 Troubleshooting
Now What Do I Do? ............................................... 6-2
Adjusting the Tools ................................................ 6-3
Adjusting the Cutter .................................................. 6-3
Circle Correction .................................................. 6-11
To Next Page
Loading...
