iii
Functions in the Jog Mode ..................................... 3-5
Setting the origin .......................................................3-5
Two-point axis alignment ..........................................3-6
Cutting area ...............................................................3-7
Digitization operation .................................................3-8
Assigning Pen Numbers ......................................... 3-9
Cutting the Same Data Again (Copy) ................... 3-11
Setting Multi-pass Cutting ..................................... 3-12
Setting Multi-pass Cutting .......................................3-12
Change the cutting (plotting) order ....................... 3-14
Set SORTING .........................................................3-14
Rotating Coordinate Axes (ROTATE) ................... 3-15
Setting the Cutter Stroke ...................................... 3-16
Setting the Displayed Units .................................. 3-17
Swivel Blade Dummy Cut ..................................... 3-18
Setting the Displayed Language (DISPLAY) ........ 3-19
Setting the Close Time ......................................... 3-20
Other Useful Functions ......................................... 3-21
Setting a Cut Quality ...............................................3-21
Setting speed of carriage movement ......................3-22
Height setting at the pen tool lifted ..........................3-23
Setting of the offset value of the cutting edge
correction pressure .................................................3-24
Make the media without uncut area ........................3-25
Setting a KEY BUZZER ..........................................3-26
Setting a START MODE .........................................3-27
Setting a JOG SETTING .........................................3-28
Setting a COMMAND ..............................................3-29
Set the configurations with a computer ...................3-32
Set the network .......................................................3-34
Setting event mail function ......................................3-36
Copy the set value from the other user setting .......3-45
Reset the setting values to the initial state. .............3-46
Switch the User .................................................... 3-47
Chapter 4 Register Mark Reading Functions
Precautions when Creating Data with Register
arks ......................................................................... 4-2
Size of Register Marks .............................................4-2
To Next Page
Loading...
