This Section....
... describes the basic operations, such as mounting tools and workpieces.
List of SET UP Functions ....................... 3-2
Functions in the Jog Mode ..................... 3-5
Setting the origin ......................................3-5
Two-point axis alignment ..........................3-6
Cutting area ..............................................3-7
Digitization operation ................................3-8
Assigning Pen Numbers......................... 3-9
Cutting the Same Data Again (Copy) ... 3-11
Setting Multi-pass Cutting..................... 3-12
Setting Multi-pass Cutting ...................... 3-12
Change the cutting (plotting) order ....... 3-14
Set SORTING .........................................3-14
Rotating Coordinate Axes (ROTATE)... 3-15
Setting the Cutter Stroke ...................... 3-16
Setting the Displayed Units .................. 3-17
Swivel Blade Dummy Cut..................... 3-18
Setting the Displayed Language
(DISPLAY)............................................ 3-19
Setting the Close Time ......................... 3-20
Other Useful Functions......................... 3-21
Setting a Cut Quality ...............................3-21
Setting speed of carriage movement ......3-22
Height setting at the pen tool lifted .........3-23
Setting of the offset value of the cutting
edge correction pressure ........................3-24
Make the media without uncut area ........3-25
Setting a KEY BUZZER ..........................3-26
Setting a START MODE .........................3-27
Setting a JOG SETTING ........................3-28
Setting a COMMAND .............................3-29
Set the configurations with a computer ..3-32
Set the network .......................................3-34
Setting event mail function .....................3-36
Copy the set value
from the other user setting ......................3-45
Reset the setting values to the initial
state. .......................................................... 3-46
Switch the User .................................... 3-47
Chapter 3
Useful Function
To Next Page
Loading...
