Minebea CSD-912B - Page 106

86
Measurement
5
5.4. Measurement in sequential mode
6HWWKHRXWSXWWLPHRIGLVFKDUJH¿QLVKVLJQDOV
(QWHUWKHRXWSXWWLPHRIGLVFKDUJH¿QLVK
signals.
$OORZDEOHUDQJHWR
Default: 0.00
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
7KHRXWSXWWLPHRIGLVFKDUJH¿QLVKVLJQDOVKDVEHHQ
VHWDQG>6(48(1&(&21752/@ZLOOEH
displayed.
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHRXWSXWWLPHRIGLVFKDUJH¿QLVK
signals.
The setting is completed if the value set by the step
2) appears under [DISCH. FINISH OUTPUT ON].
(16) [DISCH. FINISH ACTIONS] settings
6HWZKHWKHUWRH[HFXWHWDUHZHLJKWFDQFHOODWLRQFOHDUDQGZKHWKHUWRPL[WKHPHDVXUHG
objects on completion of measurement.
POINT
5HIHUWR7DUHZHLJKWFDQFHOODWLRQIRUPRUHLQIRUPDWLRQDERXWWDUHZLJKW
cancellation.
1) Display the screen to set [DISCH. FINISH ACTIONS]
1. Tap [DISCH. FINISH ACTIONS] on
[SEQUENCE CONTROL 1/3].
7KHVFUHHQWRVHW>',6&+),1,6+$&7,216@ZLOO
be displayed.
2) Set the operation of [TARE CLEAR] on completion of discharge
1. Tap [TARE CLEAR].
The screen to set the operation of [TARE CLEAR]
ZLOOEHGLVSOD\HG