Minebea CSD-912B - Page 105

85
Measurement
5
5.4. Measurement in sequential mode
(14) Settings of waiting time for discharge gate close
6HWWKHZDLWLQJWLPHIURPZKHQWKHUHPDLQLQJTXDQWLW\RIWKHPHDVXUHGREMHFWLQWKHZHLJKLQJ
KRSSHUUHDFKHVWKHYDOXHRI>=(52%$1'@XQWLOWKHJDWHRIWKHZHLJKLQJKRSSHUFORVHV
1) Display the screen to set the waiting time until the gate close
1. Tap [DCHG-GATE CLOSE DELAY] on
[SEQUENCE CONTROL 3/3].
7KHVFUHHQWRVHWWKHZDLWLQJWLPHXQWLOWKHJDWH
FORVHZLOOEHGLVSOD\HG
2) Set the waiting time until the gate close
1. Enter the waiting time until the gate close.
$OORZDEOHUDQJHWR
Default: 0.00
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
7KHZDLWLQJWLPHXQWLOWKHJDWHFORVHKDVEHHQVHW
DQG>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRIWKHZDLWLQJWLPHXQWLOWKH
gate close.
The setting is completed if the value set by the step
2) appears under [DCHG-GATE CLOSE DELAY].
(15) [DISCH. FINISH OUTPUT ON] settings
6HWWKHRXWSXWWLPHRIGLVFKDUJH¿QLVKVLJQDOV
1) Display the screen to set [DISCH. FINISH OUTPUT ON]
1. Tap [DISCH. FINISH OUTPUT ON] on
[SEQUENCE CONTROL 3/3].
The screen to set [DISCH. FINISH OUTPUT ON]
ZLOOEHGLVSOD\HG