Minebea CSD-912B - Page 116

96
Measurement
5
5.4. Measurement in sequential mode
2. Tap one of [SAFETY INPUT1] to [SAFETY
INPUT8] on I/O setting screen 4/6.
3. Tap [OK].
7KHVDIHW\FKHFNLQSXWIXQFWLRQKDVEHHQDOORFDWHG
WR>,2,1387@DQG>,26(77,1*@ZLOOEH
displayed.
POINT
7RDOORFDWHWKHVDIHW\FKHFNLQSXW
IXQFWLRQWRDQRWKHU,2LQSXWUHSHDWWKH
steps from1. to 3.
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHVHWWLQJVRI,2LQSXW
The setting is completed if the item set by the step
DSSHDUVXQGHU>,2,1387@WR>,2,1387@
(2) [BATCHING SAFETY CHECK] settings
6HWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJEDWFKLQJRIWKHPHDVXUHGREMHFW
1) Display the screen to set [BATCHING SAFETY CHECK]
1. Tap [WEIGHING OPERATION] on [MENU 1/2].
>:(,*+,1*23(5$7,21@ZLOOEHGLVSOD\HG
2. Tap [BATCHING SAFETY CHECK].
The screen to set [BATCHING SAFETY CHECK]
ZLOOEHGLVSOD\HG
2) Set the safety check input to use during batching
1. Tap one of [SAFETY CHECK1] to [SAFETY
CHECK8].
6HOHFWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJEDWFKLQJ
The screen to set [BATCHING SAFETY CHECK]
ZLOOEHGLVSOD\HG
2. Tap [ON]/[OFF].