Minebea CSD-912B - Page 117

97
Measurement
5
5.4. Measurement in sequential mode
3. Tap [OK].
7KHVDIHW\FKHFNLQSXWWRXVHGXULQJEDWFKLQJRIWKH
measured object has been set, and the screen to
VHW>%$7&+,1*6$)(7<&+(&.@ZLOOEH
displayed.
POINT
7RXVHDQRWKHUVDIHW\FKHFNLQSXWGXULQJ
batching, repeat the steps from1. to 3.
&RQ¿UPWKHVHWWLQJV
&RQ¿UP>%$7&+,1*6$)(7<&+(&.@
The setting is completed if the item set by the step
2) appears under [SAFETY CHECK1] to [SAFETY
CHECK8].
(3) [DISCH. SAFETY CHECK] settings
6HWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJGLVFKDUJHRIWKHPHDVXUHGREMHFW
1) Display the screen to set [DISCH. SAFETY CHECK]
1. Tap [WEIGHING OPERATION] on [MENU 1/2].
>:(,*+,1*23(5$7,21@ZLOOEHGLVSOD\HG
2. Tap [DISCH. SAFETY CHECK].
7KHVFUHHQWRVHW>',6&+6$)(7<&+(&.@ZLOOEH
displayed.
2) Set the safety check input to use during discharge
1. Tap one of [SAFETY CHECK1] to [SAFETY
CHECK8].
6HOHFWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJ
discharge.
7KHVFUHHQWRVHW>',6&+6$)(7<&+(&.@ZLOOEH
displayed.
2. Tap [ON]/[OFF].