Minebea CSD-912B - Page 118

98
Measurement
5
5.4. Measurement in sequential mode
3. Tap [OK].
7KHVDIHW\FKHFNLQSXWWRXVHGXULQJGLVFKDUJHRI
the measured object has been set, and the screen
WRVHW>',6&+6$)(7<&+(&.@ZLOOEHGLVSOD\HG
POINT
7RXVHDQRWKHUVDIHW\FKHFNLQSXWGXULQJ
discharge, repeat the steps from1. to 3.
&RQ¿UPWKHVHWWLQJV
&RQ¿UP>',6&+6$)(7<&+(&.@
The setting is completed if the item set by the step
2) appears under [SAFETY CHECK1] to [SAFETY
CHECK8].
(4) [RECIPE SAFETY CHECK] settings
6HWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJUHFLSHRIWKHPHDVXUHGREMHFWV
1) Display the screen to set [RECIPE SAFETY CHECK]
1. Tap [WEIGHING OPERATION] on [MENU 1/2].
>:(,*+,1*23(5$7,21@ZLOOEHGLVSOD\HG
2. Tap [RECIPE SAFETY CHECK] on
[WEIGHING OPERATION 2/2].
7KHVFUHHQWRVHW>5(&,3(6$)(7<&+(&.@ZLOO
be displayed.
2) Set the safety check input to use during recipe
1. Tap one of [SAFETY CHECK1] to [SAFETY
CHECK8].
6HOHFWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJUHFLSH
7KHVFUHHQWRVHWWKHVDIHW\FKHFNGXULQJUHFLSHZLOO
be displayed.
2. Tap [ON]/[OFF].