Minebea CSD-912B - Page 119

99
Measurement
5
5.4. Measurement in sequential mode
3. Tap [OK].
7KHVDIHW\FKHFNLQSXWWRXVHGXULQJUHFLSHRIWKH
measured objects has been set, and the screen to
VHW>5(&,3(6$)(7<&+(&.@ZLOOEHGLVSOD\HG
POINT
7RXVHDQRWKHUVDIHW\FKHFNLQSXWGXULQJ
recipe, repeat the steps from1. to 3.
&RQ¿UPWKHVHWWLQJV
&RQ¿UP>5(&,3(6$)(7<&+(&.@
The setting is completed if the item set by the step
2) appears under [SAFETY CHECK1] to [SAFETY
CHECK8].
(5) [MIXING SAFETY CHECK] settings
6HWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJPL[LQJRIWKHPHDVXUHGREMHFWV
1) Display the screen to set [MIXING SAFETY CHECK]
1. Tap [WEIGHING OPERATION] on [MENU 1/2].
>:(,*+,1*23(5$7,21@ZLOOEHGLVSOD\HG
2. Tap [MIXING SAFETY CHECK] on [WEIGHING
OPERATION 2/2].
7KHVFUHHQWRVHW>0,;,1*6$)(7<&+(&.@ZLOO
be displayed.
2) Set the safety check input to use during mixing
1. Tap one of [SAFETY CHECK1] to [SAFETY
CHECK8].
6HOHFWWKHVDIHW\FKHFNLQSXWWRXVHGXULQJPL[LQJ
7KHVFUHHQWRVHWWKHVDIHW\FKHFNGXULQJPL[LQJZLOO
be displayed.
2. Tap [ON]/[OFF].