Minebea CSD-912B - Page 172

152
Measurement
5
5.11. Settings related to measurement
1) Set [STAB. DETECTION BAND]
1. Enter [STAB. DETECTION BAND].
Unit: D
$OORZDEOHUDQJHWR
Default: 2.0
POINT
- Setting0.0 does not execute stability
detection.
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
[STAB. DETECTION BAND] has been set, and
>%$6,&)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRIWKHFRHI¿FLHQWRIWKH
detection band.
The setting is completed if the value set by the step
1) appears under [STAB. DETECTION BAND].
(2) [STAB. DETECTION TIME] settings
6HWWKHWLPHWRMXGJHWKHZHLJKLQJYDOXHDVVWDEOH7KHZHLJKLQJYDOXHLVMXGJHGDVVWDEOH
ZKHQWKHVHWGHWHFWLRQWLPHHODSVHVDIWHUÀXFWXDWLRQRIWKHZHLJKLQJYDOXHIDOOVZLWKLQWKH
VWDELOLW\GHWHFWLRQEDQGGHWHFWLRQEDQGFRHI¿FLHQWî>',9,6,21@
1) Set [STAB. DETECTION TIME]
1. Enter [STAB. DETECTION TIME].
Unit: 0.1 sec.
$OORZDEOHUDQJHWR
Default: 1.0
POINT
- Setting0.0 does not execute stability
detection.
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
[STAB. DETECTION TIME] has been set, and
>%$6,&)81&7,21@ZLOOEHGLVSOD\HG