Minebea CSD-912B - Page 173

153
Measurement
5
5.11. Settings related to measurement
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRI>67$%'(7(&7,21
TIME].
The setting is completed if the value set by the step
1) appears under [STAB. DETECTION TIME].
(3) [OPERATION OF STABILITY] settings
Set the operation condition of stability detection.
1) Set [OPERATION OF STABILITY]
1. Select [OPERATION OF STABILITY].
[ANYTIME]$OZD\VH[HFXWHVWDELOLW\GHWHFWLRQ
[WEIGHING SCREEN ONLY]:
Execute stability
GHWHFWLRQRQO\ZKHQ:HLJKLQJVFUHHQLVGLVSOD\HG
Default: [ANYTIME]
POINT
7RFRPSO\ZLWK-DSDQHVH,QGXVWULDO
Standard (JIS), select [WEIGHING
SCREEN ONLY].
&6'%FRPSOLHVZLWK-,6E\VHWWLQJ
[SET "MEASUREMENT ACT"] to
[VALID], too. Refer to "5.11.11.
'Measurement Act' batch settings" for
more information.
2. Tap [OK].
[OPERATION OF STABILITY] has been set, and
>%$6,&)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UP>23(5$7,212)67$%,/,7<@
The setting is completed if the item set by the step
1) appears under [OPERATION OF STABILITY].
5.11.6. Zero settings at power-on
(QWHUWKHVHWWLQJVWRGLVSOD\DVWKHJURVVORDGYDOXHRQ:HLJKLQJVFUHHQZKHQ&6'%
LVWXUQHGRQ$OVRHQWHUWKHVHWWLQJVWRFOHDUWKHFRUUHFWLRQYDOXHVRI]HURVHWRU]HURWUDFNLQJ
ZKHQ&6'%LVWXUQHGRQ
7RH[HFXWHWKH]HURGLVSOD\DQGWRFOHDUFRUUHFWLRQYDOXHVVHWWKHIROORZLQJLWHPV
>=(52$732:(521@]HURGLVSOD\DWSRZHURQ
>=(52&/5$732:(521@FOHDULQJFRUUHFWLRQYDOXHVDWSRZHURQ