Minebea CSD-912B - Page 78

58
Measurement
5
5.2. Preparation of measurement
2. Enter the value of [F-FALL].
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
- If the setting value of [PRELIM1] is equal
to [F-FALL] or less and the setting value
is not 0, the sequence error [SQ. ERR 3]
ZLOOEHGLVSOD\HGDWWKHVWDUWRI
measurement. Change the settings of
[F-FALL] and [PRELIM1] in order not to
meet the above condition.
3. Tap [OK].
>))$//@KDVEHHQVHWDQG>%5$1'&2'(@
ZLOOEHGLVSOD\HG
7) Set [PRELIM1]
>35(/,0@LVWKHVWDQGDUGYDOXHWRFRQWURORSHQFORVHRIWKHPHGLXPÀRZJDWHRIWKHEUDQG
KRSSHU,QFDVHRI>6,03/(&203$5$7,9(@WKHPHGLXPÀRZJDWHRSHQVZKHQWKH
ZHLJKLQJYDOXHUHDFKHV>),1$/@>35(/,0@,QFDVHRI>6(48(17,$/02'(@WKH
PHGLXPÀRZJDWHFORVHVZKHQWKHZHLJKLQJYDOXHUHDFKHV>),1$/@>35(/,0@
1. Tap [PRELIM1].
7KHVFUHHQWRVHW>35(/,0@ZLOOEHGLVSOD\HG
2. Enter the value of [PRELIM1].
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
- If the setting value of [PRELIM1] is 0 and
the setting value of [PRELIM2] is not 0,
WKHVHTXHQFHHUURU>64(55@ZLOOEH
displayed at the start of measurement.
Change the settings of [PRELIM1] and
[PRELIM2] in order not to meet the
above condition.
3. Tap [OK].
>35(/,0@KDVEHHQVHWDQG>%5$1'&2'(@
ZLOOEHGLVSOD\HG